HomeMy WebLinkAboutSD-18-28 - Supplemental - 1580 Dorset Street (51)32002001, revision A
100 Craftway Dr.
Littlestown, Pennsylvania 17340-0128
Phone: (717) 359-7131
INSTALLATION INSTRUCTIONS:
SAFETY WARNING:
ALWAYS TURN FIXTURE OFF/DISCONNECT POWER BEFORE PERFORMING MAINTENANCE!
Ensure that the AC service is OFF before any installation or maintenance. Do not switch service to ON
until the entire installation is complete.
This fixture is intended for installation in accordance with the National Electrical Code and local code
specifications. Failure to adhere to these codes and instructions may result in serious injury and/or damage
to the driver and void the warranty. These instructions do not purport to cover all details or variations in
equipment, nor to provide for every possible contingency related to installation, operation, maintenance,
or mounting situation. Should specific problems occur that are not addressed by these instructions, contact
your Sales Representative or distributor for assistance. Retain these instructions for future reference.
TOOLS REQUIRED:
- Screw drivers (phillips type and #8-10 slotted type)
- 5/32" Allen Wrench/Driver (set screws)
- Torque Wrench capable of 7-11 ft. lbs. torque
INSTALLATION:
1) TURN POWER OFF.
2) Loosen set screws on housing, if neccessary.
3) Make luminaire wiring connections to supply wires (by others):
- Green to Green
- White to White
- Black to Black
Note: If supply from pole is equipped with male connecting
wiring harness, simply remove secondary wiring harness
from luminaire outwiring for "plug to plug" connection.
4) Slip luminaire's post fitter onto pole and ensure wires are not
being pinched.
5) Orient the luminaire per one of the following scenarios:
a. No photo-eye option : Turn luminaire so that the thumb
screw in the roof is facing the street side.
b. Photo-eye option: Turn luminaire so that the photo-eye
is facing northward. Note, the photo-eye may be in the
housing door or in the roof cap depending on fixture series.
6) Torque pole fasteners as follows:
- Set Screws = 7 ft. lbs.
CAUTION! Over torquing of screws/bolts may lead to damage
or fatique of fastener.
7) Open roof by loosening thumb screw.
a. No chimney option: If necessary rotate the LED assembly
so that the "street side" marking is pointed in the correct
direction.
b. Chimney option : Remove LED assembly by disconnecting
the wire connectors. Install the glass chimney (shipped
separately in luminaire box). Then re-connect the wire
connectors and replace the LED assembly so that the
"street side" marking is pointed in the correct direction.
*Note, the LED assembly is factory installed with "street side"
facing the thumb screw in the roof.
8) Close roof and fasten thumb screw.
9) Install twist-lock receptacle if required.
a. Door location: Release spring clip or loosen screw (depends on luminaire) that secures door and swing
open to access the twist-lock receptacle. Install photo cell into twist-lock receptacle. Ensure wires are
clear of moving parts and close door. When door closes properly there is an audible "click".
b. Roof cap location: Pull decorative vent cap from roof. Install photo cell into twist-lock receptacle.
Reposition vent cap and press firmly into place.
10) Power to luminaire may now be turned on.
VX151/152, VX600, VX671,
VX681, & VX8911/8912VX LED Cage Fixtures:
LED ASSEMBLY
VX151 FIXTURE SHOWN
SET SCREWS
(OPTIONAL)
PHOTO-EYE
(OPTIONAL)
CHIMNEY
OUT WIRES